Toro 41165 - User Manual

Questions and Answers

J
John FernandezSep 12, 2025
Why is a boom section not spraying on my Toro Paint Sprayer?
- D
  Douglas JamesSep 12, 2025
  If a boom section isn't spraying on your Toro Paint Sprayer, consider these possibilities: * The electrical connection on the boom valve might be dirty or disconnected. Turn the valve off manually, disconnect the electrical connector on the valve, clean all leads, then reconnect it. * A fuse might be blown; check the fuses and replace them as necessary. * A hose might be pinched; repair or replace the hose. * A boom by-pass valve might be improperly adjusted; adjust the boom by-pass valves. * If the boom valve or electrical system is damaged, contact your Authorized Service Dealer.
K
Kristen KaneSep 13, 2025
Why won't my Toro Paint Sprayer operate in either direction?
- O
  orrjosephSep 13, 2025
  If your Toro Paint Sprayer won't operate in either direction: * Ensure the range selector is not in the Neutral position; press the brake and shift the range selector into a gear. * Make sure the parking brake was released and is releasing; release the parking brake or check the linkage. * If the transmission is broken, the control linkage needs adjustment or replacement, or the drive shaft or wheel hub key has been damaged, contact your Authorized Service Dealer.
A
Andrew LewisSep 13, 2025
Why does my Toro 41165 monitor display 6553.5 in the Application Rate setting?
- R
  Rhonda GoodwinSep 13, 2025
  If your Toro Paint Sprayer monitor displays 6553.5 when in the Application Rate setting, contact your Authorized Service Dealer because the monitor is not receiving data from the speed sensor.
E
eharrisSep 13, 2025
What does “OFL” mean on my Toro 41165 Paint Sprayer monitor?
- C
  Cody ArmstrongSep 13, 2025
  If the monitor reads “OFL” on your Toro Paint Sprayer, it means the data has exceeded the maximum allowed. Press and hold the [Reset] button to clear the monitor.
A
Anthony MurilloSep 13, 2025
How to fix a Toro 41165 Paint Sprayer when the starter does not crank?
- C
  Caitlin WrightSep 14, 2025
  If the starter on your Toro Paint Sprayer isn't cranking, make sure to press the brake pedal and shift the range selector to the Neutral position. Also, check the electrical connections to ensure they have good contact. Verify and, if necessary, replace the fuse. Finally, ensure the battery is adequately charged; if not, charge or replace it.
A
Amanda ChavezSep 14, 2025
What to do if my Toro 41165 Paint Sprayer engine cranks but won't start?
- K
  Kenneth HillSep 14, 2025
  If your Toro Paint Sprayer's engine cranks but doesn't start, begin by filling it with fresh fuel. If that doesn't work, drain and flush the fuel system before adding fresh fuel. Next, inspect the spark plug; clean or replace it if needed. Also, ensure the spark plug is properly reconnected and replace it if necessary.
S
Sean SmithSep 14, 2025
Why does my Toro 41165 Paint Sprayer engine start but not stay running?
- S
  Stephen HoSep 14, 2025
  If the engine of your Toro Paint Sprayer starts but doesn't keep running, try replacing the fuel cap. Additionally, drain and flush the fuel system, then add fresh fuel. Another solution is to replace the fuel filter. Also, check and correct or replace the fuse. Finally, check and tighten the wire connections.
B
Bailey IngramSep 14, 2025
How to troubleshoot power loss in a Toro 41165 engine?
- J
  Joy SmithSep 14, 2025
  If your Toro Paint Sprayer engine loses power, start by ensuring the fluid levels are correct by filling or draining to the full mark. Next, clean or replace the components as needed. Also, drain and flush the fuel system, then add fresh fuel. Replace the spark plug and the fuel cap.
Q
qliSep 15, 2025
What causes a Toro 41165 engine to knock or miss while running?
- B
  bennettruthSep 15, 2025
  If your Toro Paint Sprayer engine runs but knocks or misses, drain and flush the fuel system, then add fresh fuel. Reconnect the spark plug lead and replace the spark plug. Finally, check and tighten the wire connections.
E
Eric BassSep 15, 2025
Why is my Toro 41165 Paint Sprayer engine overheating?
- J
  Jonathan CameronSep 15, 2025
  If your Toro Paint Sprayer engine overheats, ensure that the fluid levels are correct by filling or draining to the full mark. Reduce the load and use a lower ground speed. Clean the engine with every use.