Why don't the displayed measurements on my Toro Paint Sprayer make sense?
If the displayed measurements do not make sense on your Toro Paint Sprayer, check the Units of Measurement to ensure that it is set correctly.
What should I do if a boom section on my Toro Sprayer does not spray?
If a boom section on your Toro Sprayer does not spray, the electrical connection on the boom valve might be dirty or disconnected. Turn the valve off manually, disconnect the electrical connector on the valve, clean all leads, and then reconnect it. Also, check the fuses and replace them if necessary. A pinched hose can also cause this issue, so repair or replace the hose. Make sure that a boom by-pass valve is properly adjusted.
Why is the distance reading inaccurate on my Toro 41177?
If the distance measurement is inaccurate on your Toro Paint Sprayer, calibrate the speed sensor.
Why does the monitor not function on my Toro 41177?
If the monitor on your Toro Paint Sprayer does not function, connect the monitor cable if it is loose or disconnected. Contact your Authorized Service Dealer if the monitor or cable is damaged.
What does it mean if the monitor reads “OFL” on my Toro 41177 Paint Sprayer?
If the monitor on your Toro Paint Sprayer reads “OFL,” press and hold the [Reset] button to clear the monitor, because the data has exceeded the maximum allowed.
Why is the speed always 0 or erratic on my Toro Sprayer?
If the speed is always 0 or erratic on your Toro Sprayer, connect the monitor cable. Also, calibrate the speed sensor.
What to do if Toro 41177 engine cranks, but will not start?
If your Toro Paint Sprayer engine cranks but doesn't start, the fuel tank may be empty, so fill it with fresh fuel. Also, dirt, water, or stale fuel could be in the fuel system, requiring you to drain and flush the fuel system and add fresh fuel. Check for a clogged fuel line and clean or replace it if necessary. Ensure the spark plug lead is connected, and replace the spark plug if it's damaged or dirty.
What to do if Toro 41177 Paint Sprayer displayed measurements do not make sense?
If the displayed measurements on your Toro Paint Sprayer do not make sense, check the Units of Measurement to ensure that it is set correctly because the Units of Measurement is set to a system other than what you expect.
What to do if my Toro 41177 Paint Sprayer will not operate in either direction?
If the Toro Paint Sprayer does not operate in either direction, press the brake and shift the range selector into a gear. Also, release the parking brake or check the linkage.
What to do if Toro 41177 monitor does not display Application Rate or Total Volume?
If the monitor on your Toro Paint Sprayer does not display the Application Rate or Total Volume, connect the monitor cable if it's loose. Clean the flow meter if it's dirty or clogged. Calibrate the flow meter.
General| Max Pressure | 3000 PSI |
|---|---|
| Hose Length | 25 ft |
| Power Source | Electric |
| Voltage | 120 V |
| Spray Pattern | Adjustable |
| Type | Airless |
| Nozzle Size | 0.015 in |
| Orifice Size | 0.015 in |
To Next Page
