Toro 74096 - Troubleshooting; Starter Not Cranking; Engine Start;Run Issues; Engine Power Loss

5-10
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
CHASSIS
Caster Fork Assembly and Bearing (Cont.)
Removal (Cont.)
5. Remove the six spring washers and one large flat washer from the caster fork shaft.
NOTE: Take note of the washer orientation.
6. Remove the front caster fork from the frame. Inspect the caster fork shaft for wear or damage (Figure 8).
NOTE: Avoid damaging seals and bearings while removing the caster fork.
7. Remove lower caster bearing seal (Figure 9).
Figure 8
Figure 9