Toro 74902TE - Page 64

g009196
Figure93
1.7.6cm(3inches)at
positionAiscorrect
3.Measureherefromthe
bladetiptothehard
surface
2.8.3cm(3-1/4inches)at
positionBiscorrect
4.MeasureatpositionAand
Bonbothsides
10.Fine-tunetheadjustmentnutonthefront
deck-liftassemblybyturningit(Figure94).
Note:T oincreasetheheight,turnthe
adjustmentnutclockwise;todecreasethe
height,turnthenutcounterclockwise.
g027344
Figure94
1.Adjustmentnut3.Reardeckadjustment
2.Jamnut4.Frontdeckadjustment
11.FormowerdecksshowninFigure95,ne-tune
theadjustmentnutonthefrontdeck-lift
assemblybyturningit(Figure95).
Note:T oincreasetheheight,turnthe
adjustmentnutclockwise;todecreasethe
height,turnthenutcounterclockwise.
Note:Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,you
canutilizethesingle-pointadjustmenttogain
moreadjustment.
g010251
Figure95
1.Adjustmentnut3.Reardeckadjustment
2.Jamnut4.Frontdeckadjustment
12.Toadjustthesingle-pointsystem,loosenthe
2boltsatthebottomoftheheight-of-cutplate
(Figure96).
g027345
Figure96
1.Boltsatthebottomoftheheight-of-cutplate
64