Greensmaster 3150Hydraulic System Page 4 -- 76
5. Rotate the motor clockwise so the motor flanges
clearthe capscrews inthe cuttingunitside plates.Align
reel motor shaft splines with cutting reel insert splines.
Slide motor shaft into reel insert.
6. Rotate the motor counter--clockwise until the motor
flanges are encircling the cap screws. Tighten two (2)
flange head screws to secure reel motor to cutting unit.
7. Remove caps or plugs from hydraulic fittings and
hoses. Connect hydraulic hoses to reel m otor (see Hy-
draulic Hose and Tube Installation in the General Infor-
mation section of this chapter).
8. After assembly is completed, verify that hydraulic
hosesandfittingsarenotcontactedbyanymovingcom-
ponents.
9. Checkoillevelin hydraulicreservoirandadd correct
oil if necessary.
Figure 56
CENTER REEL MOTOR
2
3
6
1
5
7
4
4
8
2
1. Center cutting reel motor
2. O--ring
3. Hydraulic fitting
4. O--ring
5. O--ring
6. Hydraulic fitting
7. O--ring
8. Hydraulic fitting
FRONT
To Next Page
Loading...
