Greensmaster 3150Page 1 -- 4Safety
Maintenance and Service
1. Before servicing or making adjustments to the ma-
chine, stop the engine, remove key from switch t o pre-
vent accidental starting of the engine.
2. Be sure entire machine is in good operating condi-
tion. Keep all nuts, bolts, screws and hydraulic fittings
tight.
3. Make sureall hydraulicline connectorsare tight,and
all hydraulic hoses and lines are in good condition be-
fore applying pressure to the system.
4. Keep body and hands away from pin hole leaks or
nozzles that eject hydraulic fluid under high pressure.
Use paperorcardboard, not hands,to search for leaks.
Hydraulic fluid escaping under pressure can have suffi-
cient force to penetrate skin and do serious damage. If
fluidisejectedintotheskinitmustbesurgicallyr emoved
within a few hours by a doctor familiar with this form of
injury or gangrene may result.
5. Before disconnecting or performing any work on the
hydraulic system, all pressure in system must be re-
lievedbystoppingengineandloweringcuttingunitsand
attachments to t he ground.
6. Toreducepotentialfirehazard,keeptheenginearea
free of excessive grease, grass, leaves and accumula-
tion ofdirt. Neverwash a warmengineor electricalcon-
nections with water.
7. Check allfuellines fortightness andwearon aregu-
lar basis. Tighten or repair fuel lines as needed.
8. If the engine must be running to perform a mainte-
nance a djustment, keep hands, feet, clothing and any
other parts of the body away from the cutting units, at-
tachmentsandany movingparts.Keep everyoneaway.
9. Do not overspeed the engine by changing governor
settings.Toassuresafetyandaccuracy,haveanAutho-
rized Toro Distributor check maximum engine speed
with a tachometer. Maximum governed engine speed
should be 2850 +
50 RPM.
10.Enginemustbeshutoffbeforecheckingoiloradding
oil to the crankcase.
11.If major repairs are ever needed or if assistance is
desired, contact your Authorized Toro Distributor.
12.At the time of manufacture, the machine conformed
tothe safetystandardsforridingmowers. Toassure op-
timumperformanceand continuedsafetycertificationof
the machine, use genuine Toro replacement parts and
accessories.Replacementpartsandaccessoriesmade
by other manufacturers may result in non-conformance
with the safety standards and the warranty may be
voided.
13.When changing attachments, tires or performing
other service, use correct blocks, hoist s and jacks.
Make sure machine is parkedonasolidlevelsurface
suchasaconcretefloor.Priortoraisingthemachine,re-
move any attachments that may interfere with the safe
and proper raising of the machine. Always chock or
block wheels. Use appropriate jack stands to support
the raised machine. If the machine is not properly sup-
ported by jack stands, the machine may move or fall,
which may result in personal injury.
To Next Page
Loading...
