Greensmaster 3150 Page 1 -- 5 Safety
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere withthe safe and proper raising of
themachine.Alwayschockorblockwheels.Use
jack stands tosupport theraised machine. Ifthe
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
Front End Jacking
1. Apply parking brake and chock rear tire to prevent
the machine from moving. Make sure that cutting units
are fully lowered.
2. Position jacksecurelyundertheframe jackingpoint:
A. T he left side jacking point is the frame channel
under the step behind the LH front wheel.
B. The right side jacking point is the ROPS support
bracket behind the RH front wheel (Fig. 1).
3. Jack front of machine off the ground.
4. Position appropriate jack s tands under the frame as
close to the wheel as possible to support the machine.
Rear End Jacking
1. Applyparkingbrakeandchockbothfronttirestopre-
vent the machine from moving. Make sure that cutting
units are fully lowered.
2. Place jack securely below the r ear castor fork.
3. Jack rear of machine off the ground.
4. Position appropriate jack stands under the frame to
support the machine.
1. ROPS support bracket
Figure 1
1
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the traction unit and thecutting unitsof theGreensmas-
ter 3150. If anydecal becomes illegibleor damaged,in-
stall a new decal. Part numbers are listed in your Parts
CatalogandOperator’sManual.Orderreplacementde-
cals from your Authorized Toro Distributor.
Safety
To Next Page
Loading...
