Toro Greensmaster
3150 - Groomer Brush

Greensmaster 3150Groomer Page 8 -- 18
Groomer Brush
Figure 17
1. Groomer brush shaft
2. Lock nut
3. J--bolt
4. Groomer brush
5. O--ring
20 to 25 in--lb
(2.3 to 2.8 N--m)
20 to 25 in--lb
(2.3 to 2.8 N--m)
3
1
2
4
2
3
5
The groomer brush attaches to the groomer drive in
place of the grooming reel. Removal and installation of
thegroomerbrushusesthesameprocedureasremoval
and installation of the grooming reel (see Grooming
Reel in this section).
Toremovethegroomerbrushfromtheshaft,removethe
locknutandJ--boltfrombothendsofthebrushandslide
the brush fromthe shaft. Whenassembling the brushto
the shaft, secure the a ssembly with J--bolts and lock
nuts. Make sure that the J--bolts are installed with the
threaded portion on the outside of the brush (Fig. 18).
Torque lock nuts f rom 20 to 25 in--lb (2.3 to 2.8 N--m) .
1. J--bolt 2. Lock nut
Figure 18
2
1