Greensmaster 3150Groomer Page 8 -- 10
NOTE: To prevent grooming reel shaft from turning
when installing driven pulley, use wrench on shaft flats
to hold shaft.
8. Secure driven pulleyto grooming reelshaftwith lock
nut (item 1). Torque lock nut from 17 to 21 ft--lb (24 to
28 N--m).
NOTE: Topreventcuttingreelfromturningwheninstal-
ling drive pulley, block reel with piece of wood.
9. Secure drive pulley (item 4) to cutting reel shaft.
Torque pulley to 100 ft--lb (135 N--m).
10.Insert front roller into RH groomer arm assembly.
11.Make sure that bushing (item 11) is installed in drive
plate a ssembly.
12.Apply antiseize lubricant to threads of LH groomer
arm lift rod.
13.Position LH groomer arm assembly to front roller,
groomer drive plate and cutting unit frame. Secure
groomerarmtocuttingunitwithplowbolt(item22),HOC
washer (item 16) and HOC nut (item 21).
14.SecureLHgroomerarmassemblytodrive platewith
spring washer (item 12) and lock nut (item 13).
15.Center front roller t o cutting unit and tighten cap
screws (item 10) to secure roller.
16.Install groomer drive belt(item 3) and groomerdrive
cover(item2)todriveplate(seeGroomerBeltReplace-
ment in this section).
17.If equipped, install rear roller brush to cutting unit
(see Rear Roller Brush Installation in the Service and
Repairs section of Chapter 7 -- DPA Cutting Units).
18.Check grooming reel height and mower height--of--
cut settings. Adjust as needed.
19.Install cutting unit to the machine.
20.Lubricate groomer bearings (see Groomer Installa-
tion Instruc tions).
NOTE: After greasing groomer bearings, operate
groomerfor30seconds,stopmachineandwipeexcess
grease from groomer shaft and seals.
To Next Page
Loading...
