Toro Greensmaster
3150 - Page 231

Greensmaster 3150 GroomerPage 8 -- 1 3
4. Remove grooming reel bearings and seals from
drive plate and support plate assemblies (Fig. 10):
A. Remove seals from groomer plates. Discard re-
moved seals.
B. Press bearings out of side plate housings. Dis-
card removed bearings.
Bearing Installation
1. Install new grooming reel bearings and seals into
drive plate and support plate assemblies (Fig. 13):
IMPORTANT: Bearings should be installed with ex -
tended inner races toward center of housing. Also,
apply pressure equally to inner and outer bearing
races when installing bearings.
A. Press newouterbearingfully to shoulder ofdrive
platebore.Then,installnewinnerbearinguntilinner
race contacts outer bearing race.
B. Press new bearing into support plate until it is
flush with shoulder of bearing bore.
C. Install new seals into side plates. NOTE: Seals
shouldbe installedso thelip sideofthe sealwill face
the center of the cutting reel. When bearings are
greased, grease will purge from inner s eals.
2. Install support plate to right side of cutting unit:
A. Applyantiseizelubricanttothreadsof RHgroom-
er arm lift rod.
B. Position support plate to cutting unitmaking sure
that RH groomer arm lift rod is positioned through
bushing in support plate.
C. Place spring washer and lock nut o n lift rod
threads (Fig. 12). Tighten lock nut.
D. Position motor mount to groomer support p late
(Fig. 11). Secure motor mount and support plate to
cutting unitwithtwo (2)socket headscrewsand lock
nuts.
3. Installgroomingreel,frontrolleranddrivep latetoleft
side of cutting unit (see Grooming Reel Installation in
this section).
4. Check a nd adjust grooming reel height and mower
height--of--cut settings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
NOTE: After greasing groomer bearings, operate
groomerfor30seconds,stopmachineandwipeanyex-
cess grease from groomer shaft and seals.
1. Socket head screw
2. Motor mount
3. Groomer side plate (RH)
4. Cutting unit
5. Lock nut (2 used)
Figure 11
4
2
1
3
1
5
1. Front roller cap screw
2. Grooming reel assembly
3. Lock nut
4. Spring washer
5. Groomer arm lift rod
Figure 12
4
2
1
3
5
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
5. Seal lip
6. Support plate bearing
7. Drive plate
8. Support plate
Figure 13
1
2
3
4
5
5
6
8
7
5
Groomer