Toro Greensmaster
3150 - Page 27

Greensmaster 3150 Page 3 -- 11 Engine
Disassembly (Fig. 6)
DANGER
Gasolineisflammable.Usecautionwhenstoring
or handling it. Wipe up any spilled fuel before
starting the engine.
1. Inspect carbon cannister and attached hoses for
damageorobviousleaks.Adamagedorleakingcannis-
ter should be replaced.
2. Remove components as needed using Figure 6 as
a guide.
A. If either purge hoseassembly (item 5) orT--hose
assembly (item 10) is to be removed, label ends of
hose for assembly purposes. Both of these assem-
bliesincludeacheckvalvesodirectionofinstallation
is important for correct operation of the evaporative
controlsystem.The checkvalveisnotavailable asa
separatepartsohoseassemblyreplacementisnec-
essary if the check valve or hose is faulty. To ensure
proper operation of check valves, do not attempt to
remove them from the hose assembly.
Assembly
1. Install all removed components using Figure 6 as a
guide.
A. If either purge hoseassembly (item 5) orT--hose
assembly (item 10) was removed, make sure that
installation is correct.
B. Make sure that fuel hoses are not kinked aft er
installation.Also, secureallhoseswithhoseclamps.
Figure 6
1. Leak detector tank
2. Carbon cannister
3. Cable tie (2 used)
4. Hose clamp
5. Purge hose assembly
6. Hose clamp
7. Hose (to fuel tank vent)
8. Hose clamp
9. Hose (to t--fitting)
10. T--hose assembly
11. Fresh air filter
12. Hose (to air cleaner)
13. Barbed fitting
1
3
2
6
5
4
9
8
7
4
4
4
8
10
11
12
13
Engine