Toro Reelmaster 3555 - Page 16

g020321
Figure10
1.Liftarm3.Lift-armpivotyoke
2.Carrierframeshaft
AligningtheRearCuttingUnitsto
theLiftArms
CuttingUnitsadjustedfora1.2cm(3/4inch)
orHigherHeightofCut
1.Removethelynchpinandwashersecuringthe
lift-armpivotshafttotheliftarmandslidethe
lift-armpivotshaftoutoftheliftarm(Figure11).
g003979
Figure11
1.Lift-armshaftlynchpinandwasher
2.Insertthelift-armyokeontothecarrierframe
shaft(Figure10).
3.Insertthelift-armshaftintotheliftarmand
secureitwiththewasherandlynchpin(Figure
11).
AssemblingtheCuttingUnitsto
theLiftArms
1.Insertthecapoverthecarrierframeshaftand
lift-armyoke.
2.Securethecapandthecarrierframeshafttothe
lift-armyokewiththesnapperpin.
Note:Usetheslotifasteeringcuttingunitis
desiredorusetheholeifthecuttingunitistobe
lockedinposition(Figure9).
3.Securethelift-armchaintothechainbracket
withthesnapperpin(Figure12).
Note:Usethenumberofchainlinksspecied
inthecuttingunitOperator'sManual.
g003948
Figure12
1.Lift-armchain3.Snapperpin
2.Chainbracket
InstallingtheReelMotors
1.Coatthesplineshaftofthereelmotorwithclean
grease.
2.Lubricatethereel-motorO-ringwithoil,and
installitontothemotorange.
3.Installthemotorbyrotatingitclockwisesothat
themotorangesclearthelocknuts(Figure13).
Important:Ensurethatthereelmotorhoses
arenottwisted,kinked,oratriskofbeing
pinched.
g020322
Figure13
1.Reel-drivemotor2.Mountingnuts
16