Toro TimeCutter 77301 - Disposing of Waste; Washing the Underside of the Mower Deck; Cleaning

Cleaning
W ashing the Underside of
the Mower Deck
Service Interval : After each use
Important: Y ou can wash the machine with a mild
detergent and water . Do not pressure wash the
machine. A void excessive use of water , especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
W ash the underside of the mower deck after each use
to prevent grass buildup for improved mulch action
and clipping dispersal.
1. Park the machine on a level surface, disengage
the blade-control switch (PT O), and move the
motion-control levers outward to the P ARK
position.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Attach the hose coupling to the end of the
mower washout tting, and turn the water on
high ( Figure 69 ).
Note: Spread petroleum jelly on the washout
tting O-ring to make the coupling slide on
easier and protect the O-ring.
g020098
Figure 69
1. W ashout tting 3. O-ring
2. Hose
4. Coupling
4. Lower the mower to the lowest height-of-cut.
5. Sit on the seat and start the engine.
6. Engage the blade-control switch and let the
mower run for 1 to 3 minutes.
7. Disengage the blade-control switch, shut of f the
engine, remove the key , and wait for all moving
parts to stop.
8. T urn the water of f and remove the coupling from
the washout tting.
Note: If the mower is not clean after 1 washing,
soak it and let it stand for 30 minutes. Then
repeat the process.
9. Run the mower again for 1 to 3 minutes to
remove excess water .
W ARNING
A broken or missing washout tting
could expose you and others to thrown
objects or blade contact. Contact with a
blade or thrown debris can cause injury
or death.
• Replace broken or missing washout
tting immediately , before using
machine again.
• Never put your hands or feet under
the mower or through openings in the
machine.
Disposing of W aste
Engine oil, batteries, hydraulic uid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
47