Toro TimeCutter 77301 - During Operation; Operation Safety and Adjustments

Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable ( Figure 8 ).
g027249
Figure 8
Adjusting the
Motion-Control Levers
Adjusting the Height
Y ou can adjust the motion-control levers higher or
lower for maximum comfort ( Figure 9 ).
g333847
Figure 9
Adjusting the T ilt
Y ou can adjust the motion-control levers forward or
rearward for your comfort.
1. Loosen the upper bolt holding the control lever
to the control-arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever forward or rearward.
g333846
Figure 10
3. T ighten both bolts to secure the control lever in
the new position.
4. Repeat the adjustment for the other control lever .
During Operation
During Operation Safety
General Safety
• The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
• Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur .
• Do not operate the machine while ill, tired, or
under the inuence of alcohol or drugs.
• Contacting the blade can result in serious personal
injury . Shut of f the engine, remove the key , and
wait for all moving parts to stop before leaving the
operating position. When you turn the key to the
OFF position, the engine should shut of f and the
blade should stop. If not, stop using your machine
immediately and contact an Authorized Service
Dealer .
15