Toro TimeMaster 20200 - Starting the Engine

1
2
3
4
5
6
7
G017634
Figure14
Frontcutting-heightlever
1.A:4-1/4in(10.8cm)5.E:2-1/4in(5.7cm)
2.B:3-3/4in(9.5cm)6.F:1-3/4in(4.4cm)
3.C:3-1/4in(8.3cm)7.G:1-1/4in(3.2cm)
4.D:2-3/4in(7.0cm)
1
2
3
4
5
6
7
G017635
Figure15
Rearcutting-heightlever
1.A:4-1/4in(10.8cm)5.E:2-1/4in(5.7cm)
2.B:3-3/4in(9.5cm)6.F:1-3/4in(4.4cm)
3.C:3-1/4in(8.3cm)7.G:1-1/4in(3.2cm)
4.D:2-3/4in(7.0cm)
AdjustingtheHandleHeight
Youcanraiseorlowerthehandletoapositionmore
comfortableforyou.
1.Liftthehandleslightlyandpullthehandle-locklever
rearwardtodisengagethehandle-lockpins(Figure16).
2
G016488
3
1
Figure16
1.Handle-locklever3.Notches
2.Handle-lockpin(2)
2.Rotatethehandleandalignthedesirednotchin
thehandlebrackettothehandle-lockpins;referto
Figure16.
3.Releasethehandle-locklevertosecurethehandlein
place.
StartingtheEngine
StandardModel
Pulltherecoilhandleslowlyuntilyoufeelresistance,thenpull
itsharply.Allowtheropetoreturntotheengineslowly.
Note:Ifthemachinedoesnotstartafterseveralattempts,
contactanAuthorizedServiceDealer.
Electric-startModel
Youcanstarttheengineonanelectric-startmodelbyusing
eithertheignitionkeyortherecoil-starthandle.
•IgnitionKey:
TurnandholdtheignitionkeytotheStartposition
(Figure17);whentheenginestarts,releasethekey.
Important:Donotattempttostarttheenginewith
theblade-controlbarengaged;otherwise,youmay
blowthefuse.
Note:DonotholdtheignitionkeyintheStartposition
forlongerthan5secondstopreventburningoutthe
startermotor.
10