27
10. Push the top 2 bolts down, toward the front of blower,
until the blower liner conforms to the inside of the
blower (Fig. 41). This will provide clearance between
the impeller and the liner.
11. Rotate the blower pulley to verify that the blower fan
does not hit the liner (Fig. 41). Adjust the liner if
necessary.
12. Tighten the 2 top bolts in the liner and the blower
(Fig. 41).
2
3
1
m–6220
Figure 41
1. Blower 2. Top bolt and nut
Inspecting the Bagger
Inspect the bagger attachment after the first 8 hours of
operation and 100 hours thereafter.
1. Disengage the PTO and set the parking brake.
2. Turn off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Check the tube, blower assembly, and the bagger hood.
Replace these parts if they are cracked or broken.
4. Check the bags, bagger frame, and screen. Replace
any parts that are cracked, worn or broken.
5. Tighten all nuts, bolts and screws.
Greasing the Blower
Grease the bagger belt idler arm every 25 hours (Fig. 42).
Grease the blower pivot after installing the blower into the
mounting hole (Fig. 42).
m–6982
1
2
2
Figure 42
1. Bagger idler arm 2. Grease fitting
Inspecting the Mower Blades
and Baffles
1. Inspect the mower blades and baffles regularly and
whenever a blade strikes a foreign object.
2. If blades or baffles are badly worn or damaged, install
new blades or baffles. Refer to your mower operator’s
manual for complete blade maintenance.
Installing Mower Blades
Note: In most mowing conditions, improved bagging
performance can be achieved by using bagging blades
(high lift). Contact an Authorized Service Dealer for the
proper blades for different mowing conditions.
1. Refer to the Operator’s Manual for more information.
To Next Page
Loading...
Need help?
General
