Toshiba 2010 - Fn Sticky Key

User's Manual
5-6
THE KEYBOARD
LCD display Brightness: Pressing Fn + F6 decreases the LCD display bright-
ness in increments. When you press these hotkeys, the current setting will be
displayed for two seconds by a pop-up icon. You can also change this setting
through the Monitor brightness item of the Power Save Mode window in Power
Saver.
LCD display Brightness: Pressing Fn + F7 increases the LCD display bright-
ness in increments. When you press these hotkeys, the current setting will be
displayed for two seconds by a pop-up icon. You can also change this setting
through the Monitor brightness item of the Power Save Mode window in Power
Saver.
NOTE: You cannot change the display brightness for about 18 seconds
after the LCD display turns on. To protect display quality, the brightness
level is set at the maximum value.
TouchPad: Pressing Fn + F9 enables or disables the TouchPad function. When
you press these hotkeys, the current setting will change and be displayed as an
icon.
Fn Sticky key
You can use the TOSHIBA Accessibility Utility to make the Fn key sticky, that is,
you can press it once, release it, and they press an “F number” key.