22
Using the TV’s features
2 Press v or w to select the Colour
Temperature setting (0 (warm) - 10 (cool)).
0
0
0
0
0
0
Colour Temperature
Red - Offset
Colour Temperature 7
Blue - Offset
Red - Gain
Green - Offset
Green - Gain
Reset
Blue - Gain
3 Press s or r to select the option you want
to adjust, then press v or w to adjust the
setting�
4 Press to return to the previous menu�
To return the colour temperature settings to
the factory defaults, select Reset, and then
press �
Note:
If Picture Mode is set to AutoView, you can only
adjust Colour Temperature and the range will
be - 5 to + 5.
Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression
and conversion, the picture is weak and the
picture is blurry, the picture may be improved
when using this function�
1 From the Advanced Picture Settings menu,
press s or r to select Noise Reduction,
and then press �
Noise Reduction
Auto NR On
MPEG NR Auto
DNR Auto
2 Press s or r to select Auto NR, and then
press v or w to select On or Off�
Off mode :
MPEG NR menu and DNR menu are available�
• MPEG NR mode: Low, Middle, High or Off
• DNR (Digital Noise Reduction) mode: Low,
Middle, High or Off
Adjusting the Colour Management
You can adjust the picture colour quality by
selecting from 6 base colour adjustments : Red,
Green, Blue, Yellow, Magenta or Cyan�
1 From the Advanced Picture Settings
menu, press s or r to select 3D Colour
Management�
2 Press v or w, then press v or w to select
On�
3 Press , then press s or r to select Base
Colour Adjustment�
4 Press , then press s or r to select an
item you want to adjust�
Base Colour Adjustment
Hue Saturation Brightness
Red 0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
Green
Blue
Yellow
Magenta
Cyan
Reset
5 Press w, then press v or w to select Hue,
Saturation or Brightness�
6 Press s or r to adjust the settings as
required�
Hue Saturation Brightness
Red 0 0 0
Note:
If you select colour management Off mode, this
mode is not available.
Resetting the Base Colour Adjustment
The reset function adjusts the base colour
adjustment to the factory settings�
1 From the Base Colour Adjustment menu,
press s or r to select Reset�
2 Press �
Using the LED Backlight Control
In order to improve screen visibility, the active
backlight control sets the screen brightness
automatically during dark scenes�
1 From the Advanced Picture Settings menu,
press s or r to select LED Backlight
Control�
2 Press v or w to select High, Middle, Low or
Off�
Note:
When Picture Mode is set to AutoView, Auto
mode is available.
To Next Page
Loading...
