Toshiba ACE-tronics G9 ASD - Page 104

94 ACE-tronics G9 ASD Installation and Operation Manual
Input Terminal 10 (LI2) Function
Program  Terminal  Input Terminals
This parameter is used to set the functionality of the LI2 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI2 terminal to any one
of the user-selectable functions listed in Table 7 on pg. 236.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for
additional information on the function of this terminal.
Direct Access Number — F120
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 11 (LI3) Function
Program  Terminal  Input Terminals
This parameter is used to set the functionality of the LI3 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI3 terminal to any one
of the user-selectable functions listed in Table 7 on pg. 236.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for
additional information on the function of this terminal.
Direct Access Number — F121
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 12 (LI4) Function
Program  Terminal  Input Terminals
This parameter is used to set the functionality of the LI4 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI4 terminal to any one
of the user-selectable functions listed in Table 7 on pg. 236.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for
additional information on the function of this terminal.
Direct Access Number — F122
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F120 F122
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com