24 ACE-tronics G9 ASD Installation and Operation Manual
ACE G9-120V-PCB Specifications/Layout
Table 2. Ratings Information.
Table 3. Connector Pin Assignments.
Figure 8. ACE G9-120V-PCB Layout.
Parameter Rating
Isolation Voltage
850 V
rms
Input Voltage 0 – 120 VAC +10% — Hysteresis 60/90 ±10 VAC
Input Current (Terminal) 4.8 mA ±2.5 mA
Operating Temperature 14° to 104° F (-10° to 40° C)
Input Impedance 36 kΩ
Pin Assignments
Connector 1 2 3 4 5 6 7 8 9 10
CN2 X2 F R I1 I2 I3 I4 I5 I6 X2
CN3 AM FM CC V/I IICC FP
CN5 BRAKE-A BRAKE-B BRAKE-C OUT1-A OUT1-C OUT2-A OUT2-C
CN6 PP CC RR RX P24
SW1
CAUTION
Ensure that the ground
screw is securely in
place to prevent arcing,
intermittent operation, or
system failure.
3.0/76
3.7/94
SW1 — Open or close
both switches for half or
full duplex, respectively.
SW2 — Voltage or current
selection for the V/I input.
See Figure 20 on pg. 30
for more information on
the ACE G9-120V-PCB
connections.
Note: Dimensions are in inches/mm.
Closed
Open
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
