52 ACE-tronics G9 ASD Installation and Operation Manual
System Configuration and Menu Options
Root Menus
The Mode key accesses the three primary modes of the ACE-tronics G9 ASD: the Frequency Command
mode, the Monitor mode, and the Program mode. From either mode, press the Mode key to loop through
to the other two modes (see Figure 29). While in the Freq
uency Command mode, pressing the ESC key
toggles the menu to and from the EOI Command mode and the Frequency Command mode.
The Alarm or Fault information will be displayed in the event of an active Alarm or Fault. Alarm text
will be displayed on the Frequency Command screen and on the LED screen when active. Fault
information will be displayed via the Fault screen. See Alarms and Trips on pg. 248 for more information
on Alar
ms and Trips.
Note: EOI Command mode changes are effective for EOI control Only.
Figure 29. ACE-tronics G9 ASD Root Menu Navigation.
Frequency Command Mode
Frequency Setting
While operating in the Local mode (Local LED is illuminated on the front panel), the running frequency
of the motor may be set from the Frequency Command screen. Using the Rotary Encoder, enter the
Frequency Command value, provide a Run command (F and/or R), and then press the Run key. The
motor will run at the Frequency Command speed and may be changed while running. See Figure 22. on
pg. 35 and Operation (Local) on pg. 40 for more information on the F
requency Command mode.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
