ACE-tronics G9 ASD Installation and Operation Manual 51
7 — Communication Option Board
Use this setting if using the optional Communication Board for frequency control.
8 — RX2 Option (AI1)
Used for a ±10 VDC analog input signal.
9 — Option V/I
Allows for the use of the optional voltage/current frequency-control interface.
10 — UP/DOWN Frequency
A discrete terminal may be configured to increase or decrease the speed of the motor by
m
omentarily activating the terminal by applying 120 VAC to the terminal. See F264 on pg. 131
for additional information on this feature.
11 — Pulse Input Option
Used to allow the system to use a pulsed input for frequency control. See PG Input Point 1
Setting on pg. 125 for additional information on this feature.
12 — Pulse Input (M
otor CPU)
Used to allow the system to use a pulsed input for frequency control. See PG Input Point 1
Setting on pg. 125 for additional information on this feature.
13 — Binary/BCD Input Option
Allows for discrete terminal to be used for frequency-control input.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
