38 ACE-tronics G9 ASD Installation and Operation Manual
EOI Remote Mounting w/o the ASD-MTG-KIT
Note: See Figure 25 for the dimensions and the item locations referenced in steps 1 through
5.
1. At the EO
I mounting location, mark the 3.80” by 3.56” hole and the four 7/32” screw holes.
2. Cut the 3.80” by 3.56” rectangular hole.
3. Drill the four 7/32” screw holes.
4. Attach and secure the EOI to the front side of the mounting location using the four 6-32 x 5/16”
pan head screws, the #6 split lock washers, and the #6 flat washers.
5. Connect the extension cable.
EOI Mounting Dimensions
Figure 25. EOI Mounting Dimensions.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
