Toshiba B-EP2DL Series - Replacing the Peel-Off Roller

2. MAJOR UNIT REPLACEMENT EO18-33024
2.3 Replacing the Peel-off Roller
2-9
2.3 Replacing the Peel-off Roller
1) Remove the Right Cover, Left Cover and Front Cover. (Refer to Section 2.1 Replacing the CPU PC
Board.)
2) Remove the two Roller Clips with a straight slot screwdriver, then remove the Peel-off Roller Ass’y.
3) Remove the two Peel-off Rollers and the two Roller Clips from the Roller Shaft.
4) Replace the Peel-off Roller with a new one, then reassemble in the reverse order of removal.
Roller Clip
Straight Slot Screwdriver
Peel-off Roller
Roller Clip
Peel-off Roller
Roller Shaft
NOTE: Be careful of the orientation of the Roller Clips as shown in the picture below when reassemblin
g
the Peel-off Rollers.
Roller Clip
Roller Clip