Toshiba B-EP2DL Series - Replacing the Peel-Off Sensor

2. MAJOR UNIT REPLACEMENT EO18-33024
(Revision Date: Mar. 17, 2009)
2.4 Replacing the Peel-off Sensor
2-10
2.4 Replacing the Peel-off Sensor
1) Remove the Right Cover, Left Cover and Front Cover. (Refer to Section 2.1 Replacing the CPU PC
Board.)
2) Disconnect the Connector from the CPU PC Board.
3) Pull out the Cover Shaft, then remove the Peel-off Sensor Unit.
NOTE: Apply Floil to the Peel-off Sensor Unit as shown below when replacing the unit.
4) Release the Peel-off Sensor Cover from the Hooks.
Cover Shaft
Peel-off Sensor Unit
Peel-off Sensor Unit
Connecto
r
CPU PC Board
FLOIL
Peel-off Sensor Unit
Hook
Hook
Peel-off Sensor Cover