Toshiba B-EP2DL Series - Page 15

2. MAJOR UNIT REPLACEMENT EO18-33024
2.4 Replacing the Peel-off Sensor
2-11
5) Remove the Peel-off Sensor.
6) Replace the Peel-off Sensor with a new one, then reassemble in the reverse order of removal.
Peel-off Sensor
NOTES:
1. Be careful of the orientation of the Peel-off Springs as shown in the picture below when reassemblin
g
the Peel-off Sensor Unit.
2. After replacing the Peel-off Sensor, refer to the Setting Operation Manual or System Mode Manua
l
and perform the following operations.
zPerform the sensor adjustment.
Peel-off Spring L
Peel-off Sensor Unit
Peel-off Spring R