Toshiba B-EP2DL Series - Replacing the Stepping Motor

2. MAJOR UNIT REPLACEMENT EO18-33024
(Revision Date: Mar. 17, 2009)
2.7 Replacing the Stepping Motor
2-12
2.5 Replacing the Stepping Motor
1) Remove the Right Cover, Left Cover and Front Cover. (Refer to Section 2.1 Replacing the CPU PC
Board.)
2) Remove the two Gears.
3) Remove the two screws.
NOTE: When replacing the gear, apply a small amount of Floil (8mm
3
) to each Gear Stud with a toothpick, etc.
by drawing a line around the part as shown below.
Stepping Moto
r
SMW-2x6 Screw
Gea
r
Gear Stud (2 places)
Gear Stud
FLOIL