2. PRINTER SETUP ENGLISH VERSION EO1-33087
2.7 Loading the Media
E2-13
2.7 Loading the Media
(Cont.)
When a media roll has an outside diameter exceeding 127 mm (5”) and
the inner core diameter of 76.2 mm (3”), the optional External Media Roll
Hanger is required.
1. Fit the protrusions on the bottom of the printer into the holes in the
External Media Roll Hanger.
2. Insert the Media Shaft into the core of the media roll.
3. Place it into the cuts of the External Media Roll Hanger.
4. Pull the media forward and insert the leading edge into the Fanfold
Paper Slot.
5. Refer to the previous pages to complete the media loading.
6. Close the Top Cover.
External Media Roll
Hanger (Option)
Media Shaft (Option)
Fanfold Paper Slot
To Next Page
Loading...
