Toshiba B-EX4T1 Series - Supply Specifications; Media Types, Dimensions, and RFID

7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33089
7.1 Media
E7- 1
7. SUPPLY SPECIFICATIONS
7.1 Media
Please make sure that the media being used is approved by TOSHIBA TEC. The warranty does not apply when a
problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorised service
representative.
7.1.1 Media Type
Two types of media can be loaded for this thermal transfer and direct thermal printer: label or tag. The table
below shows size and shape of the media available for this printer.
B-EX4T-GS12-QM-R [Unit: mm]
Cut mode
Rotary cutter
Label dispensing mode
Item
Batch mode Strip mode
Head-up disabled Head-up enabled
Disc cutter
Label 10.0 – 1500.0 25.4 – 256.0
3”/s.: 87.0 - 1500.0
6”/s.: 99.0 – 1500.0
38.0 – 1500.0
25.4 – 1500.0
c Media pitch
Tag 10.0 – 1500.0 ----
30.0 – 1500.0
25.4 – 1500.0
d Label length 8.0 – 1498.0 23.4 – 1498.0
3”/s.: 81.0 – 1494.0
6”/s.: 93.0 – 1494.0
25.0 – 1494.0
23.4 – 1494.0
e Tag/Backing paper width 30.0 – 120.0 50.0 – 120.0 30.0 – 120.0
f Label width 27.0 – 117.0
g Gap length 2.0 – 20.0 6.0 – 20.0
h Black mark length (Tag paper) 2.0 – 10.0
i Max. effective print width 104.0 ±0.2
Label 6.0 – 1496.0 21.4 – 252.0
3”/s.:79.0 - 1492.0
6”/s.: 91.0 – 1492.0
23.0 – 1492.0
21.4 – 1492.0
j Effective print length
Tag 8.0 – 1498.0 ----
28.0 – 1498.0
21.40 – 1498.0
k Print speed up/slow down area 1.0 (Slow down shall be 1.5 when the print speed is 14 ips.)
Label 0.08 – 0.17
Thickness
Tag 0.08 – 0.263 (30 to 50 mm width)
Maximum effective length for on the fly issue 749.0
Maximum outer roll diameter Ø200 (Ø180 when using the built-in Rewinder)
Roll direction Inside (standard)
Inner core diameter Ø76.2±0.3
Label
Tag paper
Cut position
Cut position
Stop
position
Stop
position
Feed Direction
Black Mark
(on reverse side)
Black Mark
(on reverse side)
h
e
c
e
g
h
c
d
i
i
k
k
f
j