Toshiba B-EX4T1 Series User Manual

2.PRINTER SETUP ENGLISH VERSION EO1-33089
2.11 Sensor Setting
E2-69
2.11 Sensor Setting
If a paper jam error still occurs even after a threshold setting has been
performed, register the voltage level of media to the media sensor.
Contents of the Sensor Adjust Menu
Menu Parameter
TEMPERATURE Displays the ambient temperature and
print head temperature.
Sensor
Adjust
REFLECT Registers the voltage level of tag paper’s
print area to the reflective sensor.
TRANS. Registers the voltage level of label gap to
the transmissive sensor.
PE REFL./TRANS. Registers the voltage level of no paper to
the reflective/transmissive sensor.
RIBBON Registers the voltage level of ribbon to the
ribbon end sensor.
Power OFF
System Mode
Turn on the power while holding down
[FEED] & [PAUSE] or [MODE].
• Self diagnosis
• Parameter setting
• Fine adjustment
• Test print
• Sensor adjustment
• RAM clear
• Interface setting
• BASIC mode
• RFID setting
• Real Time Clock
• Z-MODE
• USB memory
• Reset
SYSTEM MODE
<2>PARAMETER SET
<3>ADJUST SET
<4>TEST PRINT
<5>SENSOR ADJUST

Toshiba B-EX4T1 Series Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Type	Industrial Barcode Printer
Operating Temperature	5°C to 40°C
Resolution	203 dpi
Print Width	104 mm
Interfaces	USB, Ethernet
Optional Interfaces	Wireless LAN, Bluetooth
Supported Barcodes	UPC/EAN, Code 39, Code 93, Code 128, ITF, NW-7
Storage Temperature	-20°C to 60°C
Humidity	25% to 85% non-condensing