2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.3 Loading Supplies
E2- 4
2.3 Loading Supplies
1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being
drawn into the moving parts, be sure to load the media once the printer has stopped moving
completely.
2. The Print Head becomes hot immediately after printing. Allow it to cool before loading the media.
3. To avoid injury, be careful not to trap your fingers while opening or closing the cover.
WARNING!
CAUTION!
1. Be careful not to touch the Print Head Element when raising the Print Head Block. Failure to do
this may cause missing dots by static electricity or other print quality problems.
2. When loading or replacing the media or a ribbon, be careful not to damage the print head with a
hard object like a watch or a ring.
Since the print head element can be easily damaged by shock, please treat it carefully by not
hitting a hard object against it.
Care must be taken not to allow
the metal or glass part of a watch
to touch the print head edge.
Care must be taken not to allow
a metal object like a ring to touch
the print head edge.
To Next Page
Loading...
Need help?
General
