Toshiba B-EX4T1 Series - Detection Area of the Transmissive Sensor

7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33089
7.1 Media
E7- 3
7.1.2 Detection Area of the Transmissive Sensor
The Transmissive Sensor is movable from the centre to the left edge of media.
The Transmissive Sensor detects a gap between labels, as illustrated below.
<Label>
<Tag paper with square holes>
Sensor position
A
rea to be detected.
Centre of media
Print side
Min. 12 mm
Label
Gap
Label
Min. 2.0 mm
(Min. 6.0 mm when using
the cutter module.)
Sensor is movable
within this range.
Media feed direction
Sensor position
Centre of media
Min. 12 mm
Media feed direction
Min. 2.0 mm
Sensor is movable
within this range.
Square holes
(Round holes are not acceptable.)
Print side
N
OTE:
R
ound holes are not acceptable.