© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 3
2
E3E0 Paper transport jam LCF transport jam (Paper not reaching the lower
drawer feed sensor): The paper does not reach the
lower drawer feed sensor after it has passed the
LCF feed sensor.
P. 5 - 5
E400 Cover open jam Jam access cover open jam: The jam access cover
has opened during printing.
P. 5 - 2 1
E410 Front cover open jam: The front cover has opened
during printing.
P. 5 - 2 1
E420 PFP side cover open jam: The PFP side cover has
opened during printing.
P. 5 - 2 2
E430 The ADU has opened during printing. P. 5-22
E440 Side cover open jam: The side cover has opened
during printing.
P. 5 - 2 3
E450 LCF side cover open jam: The LCF side cover has
opened during printing.
P. 5 - 2 3
E480 Bridge unit open jam: The bridge unit has opened
during printing.
P. 5 - 2 4
E490 Job separator cover open jam: The job separator
cover has opened during printing.
P. 5 - 2 4
E491 Offset tray cover open jam: The offset tray cover
has opened during printing.
P. 5 - 2 5
E510 Paper transport jam
(ADU section)
Stop jam in the ADU: The paper does not reach the
ADU exit sensor after it has passed the ADU
entrance sensor.
P. 5 - 7
E520 Jam not reaching the ADU entrance sensor: The
paper does not reach the ADU entrance sensor
after it is switchbacked in the exit section.
P. 5 - 8
E550 Other paper jam Paper remaining jam on the transport path: The
paper is remaining on the transport path when print-
ing is finished (caused by a multiple paper feeding).
P. 5 - 9
E711 RADF jam Jam not reaching the original length sensor: The
original fed from the original feeding tray does not
reach the original length sensor.
P. 5 - 2 6
E712 Jam not reaching the registration sensor: The origi-
nal fed from the original feeding tray does not reach
the registration sensor.
P. 5 - 2 6
E713 Stop jam at the original length sensor: The trailing
edge of the original does not pass the original
length sensor after its leading edge has reached
this sensor.
P. 5 - 2 6
E714 Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
P. 5 - 2 6
E721 Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
P. 5 - 2 7
E722 Jam not reaching the exit sensor (during scanning):
The original which passed the read sensor does not
reach the exit sensor when it is transported from the
scanning section to exit section.
P. 5 - 2 7
E723 Jam not reaching the reverse sensor (during scan-
ning): The original which passed the read sensor
does not reach the reverse sensor when it is trans-
ported from the scanning section to reverse section.
P. 5 - 2 7
Error code Classification Contents Troubleshooting
To Next Page
Loading...
