Toshiba e-Studio 350 - Adjustment of the RADF (MR-3018)

e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 68
3.11 Adjustment of the RADF (MR-3018)
3.11.1 Adjustment of RADF Position
Perform this adjustment when the RADF is not installed in the correct position.
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF.
[A] Checking
(1) Open the RADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the RADF).
Fig. 3-84
(2) Remove the platen sheet.
Fig. 3-85
05/11