Toshiba E-STUDIO 3510C - Setup Flow for E-Mail Printing

5 SETUP FLOW
64 SETUP FLOW FOR PRINTING FEATURES
Setup Flow for E-mail Printing
E-mail printing allows users to print a file by sending the file as an E-mail message to this equip-
ment.
This equipment allows you to print a file sent to it via E-mail. This equipment will receive the
message from the POP3 account in the E-mail server and print the file.
This equipment can accept only TIFF-S, TIFF-F and TIFF-J files for printing.
Setup Flow Description/Reference
Connect this equipment Connect the machine to your network with a network cable.
Reference: QUICK START GUIDE
y Chapter 4 “CONNECTING TO THE DEVICE”
“CONNECTING TO THE NETWORK”
Set up the TCP/IP (IPv4) Assign the IP address, Subnet mask, Gateway address.
Reference: USER FUNCTIONS GUIDE
y Chapter 4 “SETTING ITEMS (ADMIN)”
“SETTING NETWORK FUNCTIONS”
“Setting the TCP/IP Protocol (IPv4)”
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the TCP/IP”
Set up the IPv6 Assign the IP address, Prefix, Gateway address.
Reference: USER FUNCTIONS GUIDE
y Chapter 4 “SETTING ITEMS (ADMIN)”
“SETTING NETWORK FUNCTIONS”
“Setting the IPv6 Protocol”
Reference: TopAccess Guide
y Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the IPv6”
Set up the E-mail Server Configure the POP3 account for this equipment in the incoming mail server
and DNS Server to enable to receive E-mail print file from the Internet.
Reference: Network Administration Guide
y Chapter 1 “SETTING UP NETWORK SERVER”
“Setting up DNS and Mail Servers”
Connecting to Internet
Receive print file
from POP3 server
Internet
E-mail Server

Ð

Ð
Ð

Ð

Ð
Ð

