86
3.SETTING OF BASIC COPY MODES
3.SELECTING FINISHING MODES (Cont.)
3
Hole Punch Mode (Optional)
When the optional hole punch unit is attached to the finisher (Optional: MJ-1024, MJ-1023), you can hole
punch your copies.
* The paper weight should be in the range of 64-209 g/m
2
. Special paper such as OHP files or labels is
excluded.
1
Place paper in the drawer(s).
- "1.SETTING COPY PAPER" Page 36
- When using this mode in bypass copying ("Bypass Copying"
Page 58), be sure to specify the paper size.
2
Place the original(s).
- "2.SETTING ORIGINALS" Page 45
3
Press the Finisher button on the basic
menu as shown in the illustration on the
right (highlighted).
4
Press the [HOLE PUNCH] button.
z Select other copy modes as required.
5
Press the [START] button.
Available paper sizes for the hole punch:
Since the number of punch holes and the distance between the
holes vary depending on the country, purchase a hole punch unit
that meets your requirements. (For details, consult your service
technician.)
To Next Page
Loading...
