e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 59
2. Copier-specific Adjustments
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode Area where the density is adjusted
0 Low-density area
1 Medium-density area
2 High-density area
Precautions after the completion of the adjustment
Nothing in particular.
Remarks
• Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may cause a
loss in MFP performance, including degradation in the image quality and a reduction in the life of the
consumables
• If the adjustment causes a toner fixing problem, decrease the values for codes 05-7905 to 7911.
To Next Page
Loading...
