Toshiba e-studio 4540c - To Adjust the Tint of Specified Colors for Twin-Color or Single-Color; Copying

e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 68
2. Copier-specific Adjustments
2.16.4 To Adjust the Tint of Specified Colors for Twin-Color or Single-Color
Copying
 Explanation
In twin-color or single-color copying, the tint of the color specified from the control panel can be changed by
adjusting the toner amount of the color (Y, M, C or K).
 Procedures
The service technician must perform all adjustments.
(1) Enter the adjustment mode [05]. Change the values of codes [7644] to [7653] to adjust the value of Y, M, C
or K for the tint of the specified color.
(2) After changing the setting value, reboot the equipment, and check the tint of the image printed in twin-color
or single-color copying.
* Select the subcode (0 to 3) depending on which toner color (Y, M, C and K) you want to change.
* When the subcode for the specified color (Y, M, C or K) is larger, the toner amount for the adjusted color
increases, when the former is smaller, the latter decreases.
* If the value is too large, the density becomes too dark and the reproducibility of gradations in the high-
density area may become blurred and degraded. Therefore, carefully perform the adjustment, while
checking the copy or print image.
* When all the subcodes are set to "0", the specified color becomes white.
Specified color
from the control
panel
Color of toner
amount to be
adjusted
[05] code Subcode
Acceptable
value range
Default
Y 0
M 1
C 2
Magenta
K
7644
3
0 to 255 128
Y 0
M 1
C 2
Yellow
K
7645
3
0 to 255 128
Y 0
M 1
C 2
Yellow green
K
7646
3
0 to 255 128
Y 0
M 1
C 2
Cyan
K
7647
3
0 to 255 128
Y 0
M 1
C 2
Pink
K
7648
3
0 to 255 128