e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 22
3. Printer-specific Adjustments
(2) Enter the adjustment mode [05]. Change the values for codes [8210] to [8212] and [8249] to [8254] to adjust
the judgmental threshold for the “Pure Black and Gray” setting.
PDL
Original
mode
[05] code Subcode
Recommended
value
Acceptable
value range
Default
Text 8252 0/1/2/3/4 Default 1 to 255 8/8/8/8/8
Graphics 8253 0/1/2/3/4 Default 1 to 255 1/1/1/8/1
PS
Image 8254 0/1/2/3/4 Default 1 to 255 1/1/1/8/1
Text 8210 0/1/2/3 Default 1 to 255 8/8/8/8
Graphics 8211 0/1/2/3 Default 1 to 255 1/1/1/8
PCL
Image 8212 0/1/2/3 Default 1 to 255 1/1/1/8
Text 8249 0/1/2/3/4 Default 1 to 255 8/8/8/8/8
Graphics 8250 0/1/2/3/4 Default 1 to 255 1/1/1/8/1
XPS
Image 8251 0/1/2/3/4 Default 1 to 255 1/1/1/8/1
Subcode Image Quality Type
0 General
1 Photograph
2 Presentation
3 Line Art
4 Advanced
* If the default value is “1”, change the “Pure Black and Gray” setting to “Off” on the Color Settings menu
of printer driver since no value smaller than 1 is provided.
When “Text, Graphic & Image” is selected for the “Apply to” setting on the printer driver setting menu,
photo areas whose colors are close to black may be treated as black because the larger the value is, the
wider the area to be printed only with K toner becomes. Therefore adjust the value carefully while
checking the copied image.
To Next Page
Loading...
