e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 54
3. Printer-specific Adjustments
After adjusting the color balance, print and check the print image quality.
If further image quality adjustments are still necessary, use the next procedure.
* This adjustment will have an effect only on Auto or Color mode printing.
(5) Enter adjustment mode [05]. Increase the values for codes [8110 to 8113] to perform fine adjustment and
increase the sharpness intensity.
• Adjust the value for [05] code corresponding to the print option to be applied (Color mode and Image
quality type).
Color
mode
Image
quality type
[05] code Subcode
Recommend
ed value
Acceptabl
e value
range
Default
General 05-8110 0/1/2
Photograph 05-8111 0/1/2
Presentation 05-8112 0/1/2
Auto /
Color
Line Art 05-8113 0/1/2
Set a value
larger than 128.
0 to 255 128
Subcode Apply to
0 Text
1 Graphics
2 Image
* Set the value in increments of approximately 5, while checking the printouts until the optimum value is
obtained.
<Hint> This adjustment affects on the following areas according to Image Quality Type:
• General, Photograph, and Presentation: Only raster data (print image)
• Line Art: Only thin lines, small text and raster data
<Note> This adjustment changes the values set in the MFP. Therefore, it will affect every user who uses
the printer by connecting it to the MFP. After the adjustment, the values changed will be applied
to all printouts for the "Sharpness" option. Carefully perform the adjustment, being aware that
the image quality of all future printouts will be changed, when printing out originals other than
the one that is used for the adjustment.
Precautions after the completion of the adjustment
The adjustment may possibly cause outlined edges, incorrect color of thin lines, jaggies, and variations in
gradation. As a result the photo image may look unnatural. Therefore, carefully perform the adjustment, while
checking the printouts.
PS3 Mac
To Next Page
Loading...
