e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 90
3. Printer-specific Adjustments
Procedures
* The service technician must perform all adjustments.
* This adjustment will have an effect only on Auto or Color mode printing.
(1) Enter adjustment mode [05]. Decrease the values for code [8070] or [8071] to reduce the limit value of the
maximum amount of toner used.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type and Halftone).
*Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Halftone [05] code Subcode Recommended value
Acceptable
value
range
Default
Smooth 05-8071 0/2/3/4/5/6/7/8/9
Detail 05-8070 0/2/3/4/5/6/7/8/9
Set a value smaller than
the default.
0 to 255 128
Subcode Paper type
0 Plain paper
2 Recycled paper
3 Thick 1
4 Thick 2
5 Thick 3
6 Thick 4
7 Special 1
8 Special 2
9 OHP
* Set the value in increments of approximately 30, while checking the printouts until the optimum value is
obtained.
Precautions after the completion of the adjustment
The adjustment may possibly cause dark areas such as shades on photo images to look unnaturally faint.
Therefore, carefully perform the adjustment, while checking the printouts.
PCL6 PS3 Mac XPS
To Next Page
Loading...
