e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 21
6. Printer-specific Adjustments (GA-1211)
(6) Select the file “Standard21.ps” remaining in the Held field of Command WorkStation. Then double-click the
file icon, or right-click it and select [Properties].
(7) The Properties menu of the printer driver appears. Click the [Media] icon from the Print Option, and then
select A4-R/LT-R in [Paper Size]. Then change the setting of [Media Type] as required. Then click [Expert
Settings].
(8) After setting all of the above, print the file “Standard21.ps”.
(9) The test pattern “Standard21.ps” is printed.
(10) Start up the Calibrator, and then click [Measure] of “Get Measurements” to measure the printed pattern.
Precautions after the completion of the adjustment
Nothing in particular.
To Next Page
Loading...
