e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 17
2. Copier-specific Adjustments
(4) Enter adjustment mode [05]. Change the values for codes [7960 to 7979] to adjust the color density.
Color to
adjust
Original mode [05] code Subcode Recommended value
Acceptable
value range
Default
Text/Photo 05-7960 0/1/2
Text 05-7961 0/1/2
Printed image 05-7962 0/1/2
Photo 05-7963 0/1/2
Y
(Yellow)
Map 05-7964 0/1/2
Text/Photo 05-7965 0/1/2
Text 05-7966 0/1/2
Printed image 05-7967 0/1/2
Photo 05-7968 0/1/2
M
(Magenta)
Map 05-7969 0/1/2
Text/Photo 05-7970 0/1/2
Text 05-7971 0/1/2
Printed image 05-7972 0/1/2
Photo 05-7973 0/1/2
C
(Cyan)
Map 05-7974 0/1/2
Text/Photo 05-7975 0/1/2
Text 05-7976 0/1/2
Printed image 05-7977 0/1/2
Photo 05-7978 0/1/2
K
(Black)
Map 05-7979 0/1/2
Set a value larger than 128
to increase the density.
Set a value smaller than 128
to decrease the density.
0 to 255 128
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode Area where the density is adjusted
0 Low-density area
1 Medium-density area
2 High-density area
After setting the values, copy and check the copy image quality.
Only if the vividness of R (Red) is still insufficient even after all the above procedures have been used, must
the service technician use the next procedure.
To Next Page
Loading...
