8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 127
[CC60] Punch motor abnormality
Is the punch motor clock sensor ((PI2P) working normally?
NO Replace the sensor.
YES
Is the punch home sensor (PI3P) working normally?
NO Replace the sensor.
YES
Is the wiring between the punch home sensor (PI3P) and finisher controller PC board
correct?
NO Correct the wiring.
YES
Is the punching mechanism normal?
YES Fix the mechanism.
NO
Is the problem solved by replacing the punch motor (M1P)
?
YES END
NO
Is the problem solved by replacing the punch driver board?
YES END
NO
Replace the finisher controller PC board.
To Next Page
Loading...
