IPedge
IPMobility Application
110 TOSHIBA
IPedge UG 12/15
Note: Use this function with the Call-thru feature, only if Calling Party
Identification is NOT being sent from your mobile device or is
unsupported by the service provider for the IPedge.
Use IPMobility to call
(Android ONLY)
Select this option if you want IPMobility to always intercept outbound dialing and
route through IPedge.
Do not use IPMobility
to call (Android ONLY)
Select this option if you never want IPMobility to be used exclusively for outbound
dialing.
Ask Every Call
(Android ONLY)
Select this option if you wish to have the IPMobility Application display a
notification that it should be used for every call.
Call Screening Select the time in seconds to wait for Call Screening operation. If 0 is specified,
Call Screening is deactivated. Please see Incoming Calls.
Call Control Tap it to toggle Activate and Deactivate the Net Server Call Control. It can be
activated when using Follow Me, and all calls to the desktop phone will be
immediately forwarded to the voice mail so that Follow Me operations starts
immediately. It is strongly recommended to ring the desk phone in Follow Me
setting. Otherwise, the call may not be taken from the desk phone. To use this
feature, the PDN of the telephone and the mailbox number must be the same.
New Message
Notification
Table 8: Notifications
Android iPhone
This will enable the automatic
message notification in the
notification bar on the Android
phone. If disabled, the “New
Message” indicator will display on
the “Messages” page.
Note: Enabling “Message
Notification” (push notification) will
set the IPMobility Application to
periodically poll the IPedge for new
messages, which may decrease
the battery standby time.
When the IPMobility App is
installed these options can be
found under Settings >
Notifications > IPMobility >
Badges, Sounds, Banners.
To Next Page
Loading...
