Toshiba IPedge - Page 65

IPedge
Feature Operations
IPedge UG 12/15 TOSHIBA 61
2. Set up / Store your personal Speed Dial numbers.
3. Assign names to personal Speed Dial numbers (on supported models).
Making a Call Using Speed
Dial
There are two ways to begin a Speed Dial Call.
1. Press Spdial on an IP5000-series digital telephone
or press the
*
button on any telephone.
2. Dial the Station or System Speed Dial Number. Station Speed Dial
numbers occupy numbers 100~199. System Speed Dial numbers occupy
numbers 200~999.
Speed Dial Capabilities Go to Enterprise Manager.
1. Click on Station > Station Assignment.
2. Click on the Basic tab.
3. Enter the desired number of SpDial Bins.
4. Set System Speed Dial to enable/disable. Default is Disable.
5. Click on the Save icon.
Long SD Numbers Up to 32 digits can be stored in one SD location. If you exceed 32 digits, the
excess digits are automatically stored in the next sequential SD location. If SD
100 contains 40 digits, then 8 of those digits would be stored in SD 101. If you
save other digits to SD101 they will over-write the eight digits automatically
stored there.
Storing Personal Speed
Dial Names
You can store names with Personal Speed Dial numbers. These names will
display as Soft Keys which can be used for dialing from the telephone LCD
directories.
Notes:
• Speed Dial locations must be assigned to your telephone by your System
Administrator before you can store names. Your System Administrator
can also associate names with Station Speed Dial numbers.
• Only the Administrator telephone can store System Speed Dial numbers.
Table 7:
Feature Feature Access Code Sequences
Speed Dial (Dialing an SD number)
Station
a
Spdial
b
+ nnn
nnn = 100~199 Station SD numbers
System
1
Spdial
2
+ nnn
nnn = 200~999 System SD numbers
a. Stations must be assigned/enabled Speed Dial capabilities in system programming.
b. If your telephone does not have a Spdial button, press the * button, then dial the three digit Speed Dial
bin number (nnn).