Why is my Toshiba Inverter in Emergency Off mode?
If your Toshiba Inverter is in 'Emergency Off' mode, you need to investigate and correct the stop condition. Ensure the reset function is operating correctly, especially if the reset button was pressed twice at the EOI. Also, identify and address the source of any remote EOFF commands. Finally, perform a reset of the ASD.
How to fix an overheating Toshiba Inverter?
If your Toshiba Inverter is overheating, implement cooling solutions to reduce its temperature. Relocate the ASD away from heat sources. Clear any obstructions to the cooling fan vent. If the cooling fan is inoperative, repair or replace it. If the internal thermistor is disconnected, reconnect or replace it.
What causes ASD Overload in a Toshiba P9 ASD Inverter?
To address an ASD Overload in your Toshiba Inverter, lower the carrier frequency setting. Reduce the load to within the ASD's capability. Increase the acceleration time setting. Adjust the DC damping rate to a suitable level. Avoid starting the motor into a spinning load after a momentary power failure. Ensure the ASD is suitable for the application.
How to troubleshoot Motor Overload on a Toshiba Inverter?
If your Toshiba Inverter reports a Motor Overload, verify and adjust the V/f parameter settings. Resolve any locking condition of the motor. Avoid continuous operation at low speed. Reduce the load on the motor. Check for and repair any disconnected or damaged cables, especially while operating in the PG Feedback Vector Control mode.
What causes Main Under-Voltage in a Toshiba P9 ASD?
If your Toshiba Inverter is experiencing a Main Under-Voltage issue, check and restore the 3-phase commercial voltage. Ensure the PO-to-PA jumper is secured or replace it if missing. Review and correct any typeform settings. Restore the externally-supplied control power.
How do I fix a Comm1 Error on my Toshiba P9 ASD Inverter?
If you're encountering a Comm1 Error with your Toshiba Inverter, review the programming of the ASD. Check and correct the communication settings. Inspect and reconnect cables as necessary.
What to do if a Toshiba P9 ASD shows Low Suction/No Flow Cut Off?
If your Toshiba Inverter is experiencing Low Suction or No Flow Cut Off, check the suction pressure and ensure the pump output valve is open. Verify the discrete input terminal configuration. Adjust the ASD Upper-Limit Frequency settings.
Why is my Toshiba Inverter showing Under-Voltage at Control Power?
If your Toshiba Inverter shows Under-Voltage at Control Power, replace the faulty control board. Reduce the load on the power supply. Check and improve the input voltage.
Specifies requirements for personnel performing installation, operation, and maintenance.
Details proper methods for routing conductors and grounding the ASD.
Provides critical safety warnings for making power connections to the ASD.
Emphasizes protection for personnel from hazards during operation.
Lists requirements and considerations for setting up the ASD within a system.
Details thermal specifications and mounting recommendations for the ASD.
Explains how to connect the ASD and its components.
Highlights severe shock hazards related to power connections.
Details requirements for connecting power to the ASD, including NEC compliance.
Describes the functions of keys, screens, and the rotary encoder on the EOI.
Introduces the Standard Startup Wizard for initial ASD configuration.
Lists the key parameters configured by the Standard Startup Wizard.
Provides step-by-step instructions for operating the motor in Hand mode.
Guides the user through configuring the VLP system using a wizard.
Lists user-notification codes for faults, alarms, and trips, and how they are displayed.
Lists P9 ASD alarm codes, descriptions, and possible causes/troubleshooting.
To Next Page
General