User’s Manual 7-5
HW Setup & BIOS Setup
HDD Priority Options
If more than one hard disk drive is installed in the computer, this option
allows you to set the priority associated with hard disk drive detection - the
first hard disk drive detected that has a valid boot command on it will be the
device from which the computer will start.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]Sets PXE as the protocol (Default).
[RPL]Sets RPL as the protocol.
USB Memory BIOS Support Type
This option allows you to set the type of the USB memory to be used as a
startup device.
Built-in HDD ->
USB
This option sets the priority as the built-in hard
disk drive followed by a USB memory device
(Default).
USB -> Built-in
HDD
This option sets the priority as a USB memory
device followed by the built-in hard disk drive.
■ If a boot command is not found on the first detected hard disk drive, the
system will not boot from next hard disk drive in the list, instead it will
search for the next device in the Boot Priority list and startup from this
as appropriate.
■ Please be aware that some modules may not be displayed.
Network Boot Protocol is not displayed for Gigabit Ethernet LAN.
HDD Sets the USB memory to be the equivalent of a
hard disk drive (default). With this setting, the
USB memory device can be used to start the
computer as though it were a hard disk drive
based on the hard disk drive settings within both
the Boot Priority and HDD Priority options
detailed previously.
FDD Sets the USB memory to be the equivalent of a
floppy diskette drive. With this setting, the USB
memory device can be used to start the
computer as though it were a floppy diskette
based on the floppy diskette drive settings within
the Boot Priority option detailed previously.
To Next Page
Loading...
