User’s Manual 1-13
Getting Started
Creating a Optical Recovery Discs
A recovery image of the software on your computer is stored on the hard
disk drive, and can be copied to either CD or DVD media by using the
following steps:
1. Select either blank CD or DVD media.
2. The application will allow you to choose from a variety of different media
onto which the recovery image can be copied including CD-R, CD-RW,
DVD-R, DVD-RW, DVD+R and DVD+RW.
3. Turn on your computer and allow it to load the Windows XP operating
system from the hard disk drive as normal.
4. Insert the first blank media into the optical disc drive tray.
■ A writable external optical disc drive that is sold separately and
compatible to the computer is required to create the Recovery Discs. It
can be purchased from TOSHIBA dealers.
■ This machine supporting the following optical disc drives for
creating optical recovery discs:
External DVD Super Multi Drive PA3454U
External CD-RW/DVD-ROM Drive PA3438U
■ Be sure to connect the AC adaptor when you create Recovery Discs.
■ Be sure to close all other software programs except the Recovery Disc
Creator.
■ Do not run software such as screen savers which can put a heavy load
on the CPU.
■ Operate the computer at full power.
■ Do not use power-saving features.
■ Do not write to the disc when the virus check software is running. Wait
for it to finish, then disable virus detection programs including any
software that checks files automatically in the background.
■ Do not use utilities, including those intended to enhance hard disk drive
access speed. They may cause unstable operation and damage data.
■ Do not shut down/log off or standby/hibernate while writing or rewriting
the disc.
■ Set the computer on a level surface and avoid places subjected to
vibrations such as airplanes, trains, or cars.
■ Do not use on an unstable surface such as a stand.
Please note that some of the above media may not be compatible with the
optical disc drive installed into your computer. You should therefore verify
the optical drive supports the blank media you have chosen before
proceeding.
Recovery discs can only be created using the RecordNow! Basic for
TOSHIBA software installed on the computer.
To Next Page
Loading...
