User’s Manual 3-19
Features, Utilities and Options
7. Seat the memory module cover in place and secure it with two screws.
Figure 3-9 Seating the memory module cover
8. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power and Power-Up Modes, if required.
9. Turn your computer over.
10. Switch the computer on and make sure the added memory is
recognized - this can be confirmed by clicking start followed by Control
Panel followed by Performance and Maintenance and then selecting
the System icon.
11. Open the System Properties window and then click the General tab.
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 1, Getting Started if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes, if required).
4. Loosen the two screws securing the memory module cover in place -
please note that those screws are attached to the cover in order to
prevent it from being lost.
5. Slide your fingernail or a thin object under the cover and lift it off.
6. Push the latches away from the module in order to release it - a spring
will force one end of the module up at an angle.
Take care to ensure that the memory module cover is firmly closed.
Screws
Memory module
cover
To Next Page
Loading...
